Mitsubishi Montero (Pajero) Gen 2.5

This one took a while longer than the Unimog. There were two extra profiles – front and back, as well as a lot more detail than the Unimog. The Unimog design is pretty simple straight lines and angles. The Montero has car-like body work to contend with.

I did take a little creative license as I always do.

• Nothing was square or straight
• I cleaned up the measurements part significantly.
• I built a complete grill separately based on a photo I had. It didn’t end up fitting exactly in the wireframe so it is stretched horizontally a bit.
• The original has an included table where the measurements are located. I just put them in directly.

Here is the original from the Shop manual: